Laser Cutter TroubleShooting

When I use laser cutter , I'd like to cut a Rectangle at 30x30mm, however, it become 30x60.2 in simulation and in laser, Please make sure "Enable rotate engrave" is not ticked. Useful link: Laser cutter reviews

If the software shows the below information: Please try the following solutions: A.Please check if the USB cable is loose or not. USB cable B.Please check if the USB is connected to the PC interface on the machine correctly C.Try connect to another USB interface on the computer D.Change another USB cable E.If you use a laptop computer, please cancel the energy saving mode. G.Reinstall the laser cutting machine software and drivers Useful link:  # Laser cutter reviews       # Laser cutter        # Laserengraverforum

If Laser cutter has a wrong cutting/engraving size, generally the pulse setting of the X/Y axis motors is wrong. Please follow the below steps to solve the problem Please draw a 100x100mm square using the cut mode and send to your laser cutter and cut the square. 100*100mm Let’s say the actual size of the square measured is 98x95mm 98*95mm How to fix this problem? Please follow the pictures below to find the “Vender settings “and then input the password. Click "Read" first.Now select the X/Y axis and revise the step length,input the numbers as the below, and the software will count the correct number automatically,then please click"Write"and then exit. After “Reset” on display and draw a new 100×100mm square, if the size is correct, the problem is fixed. If not, please repeat the step 1-3. Useful link:  # Laser cutter reviews       # Laser cutter        # Laserengraverforum