How to import PDF files into RDWorks

1. RDWorks cannot read PDF and open it directly.
2. Use CorelDraw to open/import PDF file. Then save the graphic as DXF file.
Like below:
3. Then RDWorks can read the DXF file, Just import the DXF file into RDWorks directly.
4. The other way is open/import PDF file with CorelDraw，use the plugin button "Laser Running" to import the graphic into RDWorks.



Useful Links:#laser cutter reviews    #laser machine

Comments

Post a Comment

Popular posts from this blog

How to install the CorelDraw plugin for RDWorks

Image
1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (be sure the RDWorks main program has been already installed), and then tick the item RDworks, as shown below: Click “install” and wait to compete the installation. 3. Again run CorelDraw. Choose and enter “Run Macro”(Tools > Marcos>Run Macro). Choose Marcos in: [Globalmacros (RDWorks15/16/17V8.gms)] > [RDWorksV8.UserInit]. Click run. 4. There will appear two extra buttons . Move them to anywhere you want them to be. After finish drawing the graphics, click “Laser running” to directly import the graphics into RDworks. Useful link: #laser cutter reviews
Read more

Why does the cutting and engraving graphics reverse (mirror)

Image
This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears. Make sure “Axis X mirror” is unticked, and “Axis Y Mirror” is must ticked. If your setting is different from this, this is the problem why your cutting/engraving reverse. Just reset the config as above.
Read more

How to run several laser machines with one PC via USB cable

Image
If there are several USB interfaces with your PC, it's able for one PC ( laser software ) to connect with several machines. But pc will does only communicate with one machine and sending the file into the laser in the same time For USB connection as below 1. When connecting with the first machine, it's connected automatically as default. 2. When connecting with the second machine, please click the “Add” below, then click "USB" and choose COM3 (or other ports). 3. When connecting with more machines, it's the same as 2. (Just choose different COM ports) If you use Ethernet interfaces,please refer to the following video teaching you how to set network. And the way of adding more Ethernet port is the same as above.
Read more