Cutting problem-- Why the starting point of a cutting graphic can't meet with its end point


This problem is due to the different movement of the belt on both sides of the Y-axis, which lead the belt is not synchronized.

1. The coupling loose

 2. The gear of transmission shaft loose

 1. The coupling loose;

① Please check if one of couplings is loose like below:

If yes, please tighten it in clockwise with M5 Allen wrench.

2. The gear of transmission shaft loose

Please check which side of gear of transmission shaft is unfixed like below:



If the gear loose that mean the transmission shaft module is bad please contact with us.

Besides,there are another ways to improve the cutting problem by adjusting software.

1. Reduce the User setting of Go Acc factor and Speed factor to minimize the impact Like below:



If nothing,please follow next step to tick the option of "Backlash reapy optim"

2. An option of software for optimizing that problem.

 Like below:


Then re-download the file to laser cutter and test again.

Useful link:  #Laser cutter reviews      #Laser cutter       #Laserengraverforum

Comments

Post a Comment

Popular posts from this blog

How to install the CorelDraw plugin for RDWorks

Image
1. Firstly run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (be sure the RDWorks main program has been already installed), and then tick the item RDworks, as shown below: Click “install” and wait to compete the installation. 3. Again run CorelDraw. Choose and enter “Run Macro”(Tools > Marcos>Run Macro). Choose Marcos in: [Globalmacros (RDWorks15/16/17V8.gms)] > [RDWorksV8.UserInit]. Click run. 4. There will appear two extra buttons . Move them to anywhere you want them to be. After finish drawing the graphics, click “Laser running” to directly import the graphics into RDworks. Useful link: #laser cutter reviews
Read more

How to import PDF files into RDWorks

Image
1. RDWorks cannot read PDF and open it directly. 2. Use CorelDraw to open/import PDF file. Then save the graphic as DXF file. Like below: 3. Then RDWorks can read the DXF file, Just import the DXF file into RDWorks directly. 4. The other way is open/import PDF file with CorelDraw，use the plugin button "Laser Running" to import the graphic into RDWorks. Useful Links: #laser cutter reviews     #laser machine
Read more

Why does the cutting and engraving graphics reverse (mirror)

Image
This problem may cause from improper setting of the software. Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the menu bar. This dialog box appears. Make sure “Axis X mirror” is unticked, and “Axis Y Mirror” is must ticked. If your setting is different from this, this is the problem why your cutting/engraving reverse. Just reset the config as above.
Read more